CP 1000 Processor is ideal for diagnostic clinics, remote departments, chiropractic and veterinary offices. The CP 1000 provides consistent, high-quality processing of film sizes ranging from 4" x 4" up to 14" W x 36" L for applications with moderate patient film volume.
Does not require professional installation and plumbing. Setting up and installing the CP 1000 takes less than one hour and requires only simple tools.
Options:
Light Tight Feed Tray $259.00
Processor Stand $550
Only .25 gallon of chemical is required to fill the CP 1000 Processor tanks, and they are replenished automatically. Where other processors typically require 5-gallon mixers to keep their tanks full, the CP 1000 uses pre-measured concentrates that make the right amount of developer and fixer to fill the 5-liter dispenser bottles. With the CP 1000 you mix and use less chemistry and it is always fresh.
Most processors require water, drain plumbing and external replenishment. They consume 16 to 30 gallons of water per hour. The CP 1000 requires no external plumbing, and the wash-water is supplied from its 5-liter (1.3 gallon) dispenser bottle.)
The typical processing cycle for low-volume processors is 2.5 to 3 minutes, and you must remain in the darkroom until the film has completely entered the processor, which can take over a minute. The exclusive CP 1000 Feed Tray/Light Cover allows you to leave the darkroom in about 15 seconds.
125-second cycle time (leading edge into developer to leading edge at dryer) for quick access to finished radiographers.
